60" TUFFLITE Aluminum Press Brake Die Set - 5 Piece Set Four Way, Flattening

Description

TUFFLITE Aluminum Press Brake Die Set.   You will receive the five pieces shown in the photos.  All five dies are each 60 inches in overall length.
The four way bottom die body is 1-3/8" x 1-3/8" with opening widths of 3/8", 1/2", 5/8", and 3/4".  The angle of each opening of the four way die is 90 degrees.
The flattening dies are both the same dimensionally with a 1-1/2" wide flattening surface.  Both dies are 2-5/8" in height (Not including the retention /alignment tang).  The flattening dies have minor imperfections in the working surfaces from past use.
The straight punch top die is 90 degree, with a 1/32" radius at the punch nose.  It has had a 1/2" wide, 90 degree notch milled onto it by a past user for part clearance just above the punch's point (See picture).  This die is 3-3/4" in height
(Not including the retention /alignment tang).
The gooseneck top die is 1/4" wide, with a 1/64" radius at the punch nose, has a 25 degree inside angle, and a 35 degree outside angle.
This die is also 3-3/4" in height
(Not including the retention /alignment tang).
Condition of these dies are used.  They are in good, useable condition.  All five dies have hold down dimple marks from being previously retained in a press brake for use.  Most likely, we will ship all five of the dies together.   However, we may deem it necessary to ship them in two separate packages.  Please feel free to ask questions.  We would be more than happy to provide any additional pictures if needed.